hier ist noch was: ich füge mal ein Textfile von paurice.rm von
www.arcusers.com ein.
Habe davon aber noch nichts ausprobiert (werde ich so schnell auch nicht - bin nämlich zufrieden
) und übernehme daher keine Haftung
Zitat:
|
Zitat von paurice.rm
:
So I begin with the mods, which I copy from past post:
1. PIGTAILS length:
8 ... 490mm - 19¼"
10 ... 550mm - 21½"
13 ... 600mm - 23½"
16 ... 680mm - 26¾"
19 ... 750mm - 29½"
2. SFS = Shorten Front Strap
V8 - 7 cm
V10 - 8,5 cm
V13 - 10 cm
V16 - 11,5 cm
V19 - 13 cm
This is a light wind mod, because the result is really amazing in light wind,
the power is better to go upwind, the kite turns better, and it inflates itself
better inflight.
3. TET = Trailing Edge Tuck
the base of the V16 initial mesurement.
middle : 7 center rams tips : the rest of the rams, but not the smallest (the
last) be carefull you should loose upwind ability in bigger size, don't forget
to release the internal strap arround 75%.
Size middle tips
8m² 21mm 11mm
10m² 24mm 12mm
13m² 27mm 14mm
16m² 30mm 15mm
19m² 33mm 16mm
Pros = more power, light wind
cons = less depower ???
4. BB = Bobs Bridle Line
BOB BRIDLE LINE LENGTH :
Venom 8 : 474 cm
Venom 10 : 530 cm
Venom 13 : 604 cm
Venom 16 : 670 cm
Venom 19 : 745 cm
pros = more stable in turns, low wind ability
cons = saftey ???
5. Shoulder strap shorten
On each shoulder strap (inside of the both inflation zips) you shorten the first
strap about 5cm on each side.
pros = low wind ability
cons = ?
6. Center Adjuster strap shorten you tighten the strap with the adjuster about
10cm. The internal adjuster should be pull in about 75%.
pros = low wind ability
cons =
"If you are going to run a mega tight leach in the middle of the kite it is
advised that the first point where the leach attaches to the bottom skin is
reinforced .(the leach floats for 5 cells and is then sewn in)"
|
Grüße
Tom